My idea is to have a vertical meter for the long snapper with a bar moving up and down with an accuracy bar in the middle whose width is determined by the skill of your long snapper.
After selecting your accuracy for the snap, a circular meter will appear by your holder. The circle will have a bullseye, and inner ring and an outer ring. A small ball will bounce around the target pong style, but will always pass the bullseye on each pass.
Once you select your hold accuracy the final kicking meter will appear. This will be similar to what exists now, but your maximum accuracy will be dependent on your snap and hold placement. A good snap and hold will reward you with a wider kick accuracy bar on the meter. A bad snap and hold will require a much more accurate kick as the accuracy window will be greatly narrowed due to the bad snap and hold.
This would allow for potentially bad snaps that sail over your holders head, or a catastrophic hold where the holder muffs placing the ball down.
It might be a bit much, but the current method is easy I rarely miss anything unseen 55 yards. Including the long snapper and place holder in the kicking process would make every kick an event, and not something you can sleepwalk through.

Comment