Is there a way to....

Collapse

Recommended Videos

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • PInck33
    Rookie
    • Aug 2002
    • 225

    #1

    Is there a way to....

    hit the cutoff man in WSB..I've tried every button I could think of but only can throw to the bases but when I play the cpu they hit the cutoff man with out any probs whatsoever
  • Heelfan71
    Hall Of Fame
    • Jul 2002
    • 19940

    #2
    Re: Is there a way to....

    I think every button works. I usually hit the same button as the base I am throwing too. You have to time it right for it to work. Hit it a a little before the ball gets to your guy.
    My Fan Page http://theusualgamer.net/MyFanPage_Heelfan71.aspx
    Heelfans Blog http://www.operationsports.com/Heelfan71/blog/

    Comment

    • PInck33
      Rookie
      • Aug 2002
      • 225

      #3
      Re: Is there a way to....

      Ok now I'm confused...if i understand you correctly to hit the cutoff man for example i had a play at the plate i would hit X on the xbox controller 2wice since its the button for home?

      Comment

      • Heelfan71
        Hall Of Fame
        • Jul 2002
        • 19940

        #4
        Re: Is there a way to....

        yeah. Like I said, I think any button works for the cutoff man. You would hit x to throw home, then hit any of the buttons again to cut the ball. I personally would just hit x twice. You just have to time it right. A real pain in the rear.
        My Fan Page http://theusualgamer.net/MyFanPage_Heelfan71.aspx
        Heelfans Blog http://www.operationsports.com/Heelfan71/blog/

        Comment

        • FatPitcher
          *SPN B*s*b*ll
          • Jul 2002
          • 885

          #5
          Re: Is there a way to....

          I don't think there was any way to cut the ball off and hold it. If you pressed (or mashed, even better) any of the base buttons before the throw passed the cutoff man, you would cut off the ball and throw it to the base you were mashing.

          Comment

          Working...