|
Quote: |
|
|
|
|
Originally Posted by patchm00 |
|
|
|
|
|
|
|
|
Wait a second, I'm confused . when you say "tapping the corresponding base", do you mean the x, y...etc buttons or the dpads? And, when you say the base you want them to go to, how do you distinguish between the lead base runner vs the second/third and hitter? If you could give a scenario of runners on 1st and 2nd and the batter hits a line shot to the gap. I usually just hold down R1 and make them all advance but I too have the problem of sometimes leaving the hitter on 1st in that situation.
thanks
|
|
|
|
|
|
It is very confusing and I'm strictly repeating what I believe to be true. I'm not a hard core "Shower" so I'm sure there are plenty of game pro's out there that have this nailed.
Anyway, let's say runners on 1st and 2nd. So the active controls are Triangle ( 2nd base ), O ( 1st base ) and X ( home plate ).
What I know for sure in this scenario is if the batter smacks a base hit I'll hit Triangle and then home plate on the D-Pad. This sends the runner from 2nd at full speed home. I will sometimes over ride the sliding ( I think ) by calling a head first slide to home ( Right Joystick pushed up ). The runners usually end up on 1st and 2nd respectively since I did not advance any runner.
What I'm trying to figure out now is what happens when the above scenario I select the runner on 1st and have him run to 3rd? Will the lead runner continue to home? I'm thinking Yes but so far I've choked in every opportunity to realize this.
Hope that helps.